112 operator console commands7/6/2023 ![]() $djes2 display the current activity in the JES2 address space, Outstanding I/O, Active address spaces, Active networking devices.The command prefix is £ or $ depending on your system and keyboard d tcpip,tcpip,netstat,HOME display the IP addresses used by this TCP stack.d TCPIP,NETSTAT,CONN if only one TCP address space.d TCPIP,TCPIP99,NETSTAT,CONN if more than one TCPIP, specify which one ( eg TCPIP 99).It may give 1 TCPIP99 CS V2R3 ACTIVE,2 TCPIP CS V2R3 ACTIVE d TCPIP what TCP stacks are available.d ssi,sub=csq9display the subsystem of interest.setssi add,s=dbcg,i=dsn3ini,initparm=’csqnEPX,-DBCG,M’.%csq9 start qmgr %csq9 matches from previous line.setssi add,s=csq9,i=csq3ini,initparm=’CSQ3EPX,%CSQ9,M’.setprog apf,add,dsn=csq.scsqauth,volume=myres1 make a library APF authorised.d grs,e,c list the resource every one is waiting on.d grs,c to list resources with contentions.d grs,res=(SYSDSN) for finding out enqueues etc on resources.d grs,res=(*) what resources you can display on. ![]() p jobname.id,A=1234 for example when S CICS.CICS1, and S CICS,CICS2 was issued.p procSto p a “system” job – if they are set up to listen to the stop command.s proc You start many “system” jobs via a proclib member.d ssi displays the configured subsystems.d iplinfo gives IPL time as well as parameters used during IPL.d xcf,strname=xxxx displays info about an individual structure.d u,vol=a3res1 display the unit with this volume.d a,l,userid=PAICE display what jobs are active for the given userid.d r,l What replies are outstanding – first point of call when things are “hanging”.k n,PFk=(001,CMD=’d a,l d ts,l’) sets the pf key to the command strings separated by.k e,n remove nth message from the top of the screen – useful of the messages do not scroll.k s,del=n stop messages scrolling off the top.k s,del=rd have message scroll off the top automatically.k q clear the backlog of queues messages.k e,d remove the bottom “out of line display” area.k d,fscroll forward, sometimes pf8 does this.Some commands, eg display commands comes up in a “out of line” frame at bottom of the screen k a,6,6 makes two areas A and B, can then use D A,L,L=B for to display the command D A,L in window B.You may need to do k e,d to remove the area first k a,none – removes “out of line area” from console. ![]()
0 Comments
Leave a Reply. |